How to reset a leak controller for a water filtration? HMDigital LBS-10 and SAVANT AS-414.

(HMDigital LBS-10)

(SAVANT AS-414)

Leak controller – solenoid and front control element.

(SAVANT AS-414)

(HMDigital LBS-10)

Leak controller – solenoid and back control element.

(HMDigital LBS-10)

(SAVANT AS-414)

Wipe the sensor – make sure that the wiping cloth is dry.

When a leak occurs the
LeakBlock Sensor will latch
the solenoid closed and
sound “Beep-Beep-Beep”.

The alarm will continue
until LBS-10 LeakBlock
Sensor is Reset.

Press once on the “Close” button. (HMDigital LBS-10)

Press “Reset” button for 3 seconds. (HMDigital LBS-10)

Only press “Reset” button for 5 seconds.
(SAVANT AS-414)

If a leak occurs Simply shut off the incoming water supply, first press “Close” button and after press “Reset” button for 3 seconds on the LeakBlock Sensor. A “Beep” will sound indicating the LeakBlock Sensor is ready for use. Make sure the surface where you place the LeakBlock Sensor is clean and dry.

Attention!

Pressing “Reset” button

Don’t touch the moisture sensor!